Hardware Installation

Opening the 6386/SX WGS

Follow these steps to remove the cover:
1.
Be sure the system power is turned OFF. If any cables have been
connected to the system module, disconnect them.
2.
Unlock the cover lock. (A set of keys is packed in a plastic bag in
the carton with the system module.)
3.
Loosen the three main cover-securing screws
(A, B,
and
C)
on the
back panel as shown in Figure 2-4.
A
B
co

Figure 2-4. 6386/SX WGS Main Cover-Securing Screws

4.
Slide the cover off the system module by pulling it forward until it
clears the back half of the chassis. Then tilt the back of the cover
up and remove it. Take care not to catch the cover on any internal
cables or wires.
2-9