Hardware Installation

You can see that Card 0 has an O.S. Index number of 1. Card 1 has an O.S. Index number of 2. Therefore, you need to change the DIP switch setting for Card 0, which is the first board. Determine if the settings for Card 0 match Configuration B or C in Figure 2-28.If the settings match Configuration B, change the settings to those of Configuration C. If they match Configuration C, then change the settings to those of Configuration B. Proceed to Step 7.

7.Shut down the system and turn the power OFF.

8.Open the case and change the DIP switches.

9.Close the case and turn the power ON.

10.Follow the procedure outlined in Renumbering Voice Channels which immediately follows.

11.Now that you have renumbered the channels, you want to verify the status of the boards. Follow the instructions in Step 4. If the board is still not recognized properly and you have determined that the slide switches do not appear to be the problem, call the next tier of support for assistance.

Renumbering Voice Channels

After you have reset the board switch settings, you must administer the changes in the AUDIX Voice Power system. Follow the steps below to accomplish this.

1. Log into the system as a u d i x .

2.At the User Login menu, move the cursor to Voice System

Administration and press (Enter).

The Voice System Administration window appears.

3.Move the cursor to Configuration Management and press (Enter).

The Configuration Management window appears.

2-47

Page 67
Image 67
AT&T 2.1.1 Renumbering Voice Channels, Voice System Administration window appears, Configuration Management window appears