Hardware Installation

General Instructions

for Installing Circuit Boards

All expansion boards are installed according to the following general instructions. The expansion slot to be used is described in the section on preparing the individual boards.

Follow these steps to install an expansion board:

1.Refer to Figure 2-8.Remove the slot cover by removing the screw

(A)from the metal cover (B). Then lift out the metal cover. Save the screw to secure the board in place later. On the 6386 and 6386E WGS processors, there may be a plastic cover over the slot as well as the metal cover. If a plastic cover is present, break it out with the screwdriver and discard it.

2.Holding the expansion board by its edges, insert the board into the correct slot as shown in Figure 2-9.

Be sure that the bracket on the expansion board is at the back of the chassis (top of the chassis for floor models) and fits into the space left by the slot cover. Be sure that the connector edge of the board is properly aligned with the socket on the adapter board. The front edge of long cards goes in the alignment guide attached near the front (bottom on floor models) of the computer enclosure.

2-14

Page 34
Image 34
AT&T 2.1.1 manual General Instructions For Installing Circuit Boards