Paradyne 6800 manual Formatting the Third Hard Disk, Safe to Power Off Press Any Key to Reboot

COMSPHERE 6800 Series Network Management System

b.For the 15000 system, you must shutdown and power off. Then, power on to activate the kernel. To do this, remove the floppy disk and cartridge tape, and

TYPE: cd /

PRESS: Enter

TYPE: shutdown -g0 -y -i0

PRESS: Enter

When the system prompts:

** Safe to Power Off **

- or -

** Press Any Key to Reboot **

Rotate the key counterclockwise 1/4 turn to the vertical SWITCHED OFF position. Wait at least 45 seconds for the processor to power down. Then, rotate the switch clockwise 1/4 turn to the RUN position. The system will reboot.

Formatting the Third Hard Disk

On host processors with the Automatic Backup and Restore package, you must format the third hard disk required by that package. The Automatic Backup and Restore package is always present on the Altos 15000 host. To format the third hard disk, perform the following steps:

1.After rebooting the processor, when the following message appears:

Type (CONTROL-d) to proceed with normal startup (or give root password to enter system maintenance):

TYPE: root password

PRESS: Enter

2.At the UNIX system prompt, TYPE: cd /usr/nms/adm PRESS: Enter

TYPE: ./install3hda

PRESS: Enter

NOTE

If the disk has already been installed and formatted, the following message appears:

The 3rd hard disk is already installed.

Skip the remaining steps and proceed to Step 5.

5-26 January 1997 6800-A2-GN22-30