Paradyne 6800 manual Etc/tz, Installing NMS Release

COMSPHERE 6800 Series Network Management System

3.Set the proper time zone by entering the command

/etc/tz

The system asks:

Are you in North America? (y/n) TYPE: y (as appropriate) PRESS: Enter

The system displays a list of time zones for the specified continent and prompt:

Enter the number that represents your time zone or enter q to quit: TYPE: the number of the appropriate time zone

PRESS: Enter The system asks:

Does daylight saving time (summer time) apply at your location? (y/n) TYPE: y or n (as appropriate to your location)

PRESS: Enter

4.You are now ready to execute the installpkg command and begin the installation process. To do this,

TYPE: installpkg

PRESS: Enter

The installation program prompts you to insert a floppy disk into the disk drive and press Enter.

5.Insert the disk labeled 6800 NMS Application Volume 6 into the floppy drive and the tape labeled 6800 NMS Application Volume 7 into the tape drive.

PRESS: Enter

A series of status messages appears showing that the installation program is reading and processing the contents of the floppy disk.

6.The following message appears:

Installing NMS Release 4.2.

7.At this point, the installation program will check for the existence of a previous release of the NMS.

If a previous release of NMS is found, the system prompts regarding how to remove it. If an active workstation is found, the system prompts regarding how to remove it.

5-22 January 1997 6800-A2-GN22-30