Paradyne 6800 manual Init Single User Mode

Loading and Restoring Software

The system will display several status messages followed by:

Installation and configuration of the Altos/SCO UNIX System V Operating System is now complete. Remove the Filesystem (Volume 2) floppy and the Cartridge tape (Volume 3) AFTER the system is shutdown, and press <Return> to restart the system.

** Safe to Power Off ** -or

** Press Any Key to Reboot **

CAUTION

Do not remove the boot floppy or tape until the Press Any Key to Reboot prompt is displayed.

11.Remove both the floppy disk and the cartridge tape. PRESS: any key

to reboot the system. The system auto-boots; on a System 5000, do not press the spacebar to interrupt auto-boot. The following prompt appears:

Boot

:

PRESS: Enter

INIT: SINGLE USER MODE

Type CONTROL-d to proceed with normal startup, (or give root password for system maintenance):

NOTE

You have approximately 10 seconds to type the root password and press the Enter key to select system maintenance. Failure to do so within the

10-second window will load to normal start-up. If this occurs, a reboot is necessary.

12.To go into the system maintenance mode: TYPE: root password

PRESS: Enter

13.Insert the 6800 NMS Application Volume 4 floppy disk and 6800 NMS Application Volume 5 cartridge tape.

14.At the # prompt, TYPE: installpkg PRESS: Enter

6800-A2-GN22-30 January 1997 5-11