AMX Installing the DAS-SIRIUS Tuner Module, Tuner 1 Jumper Settings, Tuner 2 Jumper Settings

DAS-SIRIUS Tuner Module

Tuner 1 Jumper Settings

The Tuner Module installed in position 1 must be set to Tuner 1, as shown in FIG. 7:

	TUNER 1 Jumpers
TUNER 2 Jumpers	TUNER 1 Jumpers

TUNER 2 Jumpers

FIG. 7 Tuner Module - Tuner 1 Jumper Configuration

Tuner 2 Jumper Settings

The Tuner Module installed in position 2 must be set to Tuner 2, as shown in FIG. 8:

	TUNER 1 Jumpers
TUNER 2 Jumpers	TUNER 1 Jumpers

TUNER 2 Jumpers

FIG. 8 Tuner Module - Tuner 2 Jumper Configuration

Installing the DAS-SIRIUS Tuner Module

Since Mi-Series and Tango Audio Controllers are shipped with a DAS-AMFM Tuner Module pre- installed in the Tuner 1 position (on the rear panel of the Controller - see FIG. 9), the DAS-SIRIUS Tuner Module, is typically installed in position #2 (labeled Tuner Option).

Installing the DAS-SIRIUS Module Into Position 2

To install the DAS-SIRIUS Tuner Module into the Position 2 Tuner slot:

1.Remove the cover from the Audio Controller.

2.Remove the Tuner Option cover plate on the rear panel (FIG. 9) to expose the Position 2 mounting slot for the Tuner Module.

3.Carefully insert the DAS-SIRIUS Tuner Module into the Controller, with the

electronics facing up, and replace the cover plate screws to secure the Module to the Controller.

DAS-SIRIUS Sirius Tuning Module for Mi-Series Audio Controllers 5