AMX manual DAS-SIRIUS Tuner Module, Overview, Installation

DAS-SIRIUS Tuner Module

DAS-SIRIUS Tuner Module

Overview

Add Sirius satellite radio functionality to your AMX Distributed Audio system with the

DAS-SIRIUS Satellite Radio Tuner Module (FG1110-02).

Tuner

Mounting

Plate

SIRIUS Antenna connector

FIG. 1 DAS-SIRIUS Satellite Radio Tuner Module

Tuner Jumpers

20-pin Tuner Ribbon Cable connector

“SIRIUS”, the SIRIUS dog logo, and channel names and logos are trademarks of SIRIUS Satellite Radio Inc. All rights reserved.

The DAS-SIRIUS Tuner Module can be used with both Mi-Series and Tango Audio Controllers.

All Mi-Series and Tango Audio Controllers come equipped with a DAS-AMFM AM/FM Tuner Module. Since Mi-Series and Tango Audio Controllers support 2 Tuner Modules in any combination, the DAS-SIRIUS Module can either be installed in addition to the DAS-AMFM Module, or the DAS-AMFM Module can be removed to allow 2 DAS-SIRIUS Modules.

Each Tuner Module uses 1 source input on the Audio Controller.

Installation

Installing/removing Tuner Modules requires removing the cover from the Audio Controller, removing the Tuner Option cover plate from the rear panel of the Controller, installing the Tuner Module, and setting Jumpers on both the Tuner Module (to specify each Tuner Module as either TUNER 1 or TUNER 2), and the rear board pin-bus of the Audio Controller (to enable/disable Tuner Module slots 1 and 2).

Disconnect all power sources before opening the chassis. Failure to disconnect power before performing this installation may cause injury or death.

DAS-SIRIUS Sirius Tuning Module for Mi-Series Audio Controllers 1