AMX DAS-SIRIUS manual Audio Controller Jumpers Dual Tuner Setting, Das-Sirius

DAS-SIRIUS Tuner Module

Audio Controller Jumpers - Dual Tuner Setting

With the DAS-AMFM Tuner Module installed in position 1, and the DAS-SIRIUS Tuner Module installed in position 2, the Audio Controller jumpers should all be set to ON, as shown in FIG. 5:

TUNER 1

Jumpers

TUNER 2

Jumpers

3

1

3

1

Top Left of Rear-Board Pin Bus

3 Tuner 1 jumpers (in ON position)

1

3

1 Tuner 2 jumpers (in ON position)

FIG. 5 Audio Controller Jumper Configuration (Dual Tuners)

Move the TUNER 2 jumpers to the ON position by connecting the top 2 sets of pins (pins 3-2) and leaving the bottom pins (pin 1) exposed.

DAS-SIRIUS Tuner Module Jumper Settings (Standard Installation)

There are 2 sets of Jumpers on the DAS-SIRIUS Tuner Module (FIG. 6). These must be set to differentiate Tuner 1from Tuner 2 in the Controller.

Since Mi-Series and Tango Audio Controllers are shipped with a DAS-AMFM Tuner Module pre- installed in position 1, as Tuner 1, the DAS-SIRIUS Tuner Module, is typically installed in position #2 (labeled Tuner Option), as Tuner 2.

DAS-SIRIUS	DAS-SIRIUS Tuner 1 & 2 Jumpers
Tuner Module

20-pin Tuner

Ribbon Cable

Connector

FIG. 6 DAS-SIRIUS Tuner Module - Tuner 1 & 2 Jumper locations

4 DAS-SIRIUS Sirius Tuning Module for Mi-Series Audio Controllers