DAS-SIRIUS Tuner Module

TUNER 1

TUNER 2

FIG. 9 Rear Panel Tuner with Tuner Option cover plate

Position 1

(DAS-AMFM installed)

Position 2

(Tuner Option cover plate)

Be careful not to damage the white ribbon cable on the top of the Tuner Module.

The Rear Panel connector at the end of the Tuner Ribbon Cable is connected to the Controller’s rear board pin-bus (see FIG. 2).

Keep the Tuner Ribbon Cable oriented so that the red stripe is always on top, as indicated in FIG. 10:

RED STRIPE (to Pin 1)

not used

 

 

Tuner 2

 

Tuner 1

 

FIG. 10 Tuner Ribbon Cable

Rear Panel

4.Connect the Tuner 2 connector on the ribbon cable to the 20-pin Tuner Ribbon Cable connector on the DAS-SIRIUS Module (FIG. 11).

Keep the Tuner Ribbon Cable oriented so that the red stripe is always on top, as indicated in FIG. 10.

Verify that all of the 20-pin connectors of the Tuner Ribbon Cable are securely plugged into their respective boards.

5.The Controller should only be powered back on once all Tuners are installed.

Removing Tuner Modules

In some cases it is necessary to remove the existing Tuner Module, in order to install a different Tuner Module. Since each Tuner Module uses 1 source input on the Audio Controller, you may choose to use the source input for other purposes.

1.Remove the cover from the Audio Controller.

2.Carefully remove the ribbon cable from the Tuner Module.

3.Remove the screws from the Tuner Module cover plate (on the Controller’s rear panel) and carefully slide the Tuner Module out of the chassis.

6

DAS-SIRIUS Sirius Tuning Module for Mi-Series Audio Controllers

Page 10
Image 10
AMX DAS-SIRIUS manual Removing Tuner Modules, Rear Panel Tuner with Tuner Option cover plate