Belt Replacement
To avoid damaging belts, DO NOT PRY
BELTS OVER PULLEYS.
RIDER DRIVE BELT
Replacement of the rider drive belt requires removal of the transmission and carrier frame. Should the drive belt ever fail, contact your dealer for replacement.
MOWER BELT - 30”
See Figure 31.
1.Mower does not need to be removed to install a new belt. However, for easier access, mower can be removed following steps in “Mower Removal and Installation.
2.If mower is not removed, place mower in lowest cut- ting position. Pull idler pulley arm (A) towards you to relieve belt tension. Remove belt from idler pulley (B) and center arbor pulley (C).
3.Remove belt from front idler pulley (D) and PTO pul- ley (E).
4.Replace old belt with new belt. Make sure
(B). Check belt pattern as shown.
5.Install mower if it was removed, and install belt on PTO pulley (E).
MOWER BELT - 34”
See Figure 32.
1.Mower does not need to be removed to install a new belt. However, for easier access, mower can be removed following steps in “Mower Removal and Installation.
2.If mower is not removed, place mower in lowest cut- ting position. Push idler pulley arm (A, Figure 32) away from you to relieve belt tension. Remove belt from idler pulley (B) and PTO pulley (C).
3.Remove the three capscrews (D, Figure 31) securing the
4.Remove old belt from arbor pulleys and replace with new belt. Make sure
5.Install mower if it was removed, and install belt to PTO pulley (C, Figure 32). Push idler arm and install belt around idler pulley.
*2391
Figure 31 Belt Pattern - 30” Mower
A. Idler Pulley Arm | D. Front Idler Pulley |
B. Idler Pulley | E. PTO Pulley |
C. Center Arbor Pulley | (Electric Clutch) |
|
|
|
|
Figure 32. Mower Belt Replacement - 34”
A. Idler Pulley Arm | D. Capscrews |
B. Idler Pulley | E. Arbor Cover |
C. PTO Pulley |
|
|
|
|
|
Figure 33. Belt Pattern - 34” Mower
A. Idler Arm Pulley | D. Right Arbor Pulley |
B. Idler Pulley | E. Left Arbor Pulley |
C. PTO Pulley |
|
28
