Snapper 400 / 2400 manual Front-To-Back Leveling

Adjustments

Figure 28. Leveling The Mower Side-to-Side

A.Nut

B.Eccentric Nut

C.Rear Rollers

*2399

Front-To-Back Leveling

1.Make sure mower is level side-to-side and that rear rollers are on the ground.

2.Position blade(s) front-to-back. Measure the distance from the ground to front tip of blade(s), and from ground to rear tip of blade(s).

On 30” mower, the front tip should be level to 1/8” (3 mm) higher than rear tip.

On 34” mower, the front tips should be 1/4” (6 mm) higher than the rear tips.

3.See Figure 29. Loosen jam nut (E). To lower rear of mower deck, loosen nut (B) which will lengthen level- ing rod (D). To raise rear of deck, shorten leveling rod

(D). When proper measurement is obtained, tighten nut (A) against bracket, then tighten jam nut (E) against nut (A).

*2397

Figure 29. Front-To-Back Levelling

A. Adjustment Nut	D. Levelling Rod
B. Rear Nut	E. Jam Nut
C. Bracket

26