Use the tool, accessories, etc., in accordance with these instructions and in the manner intended for the particular type of tool, taking into account the working conditions and the work to be performed. Use of the tool for operations different from those intended could result in a hazardous situation.
Service
Have your tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the tool is maintained.
Develop a periodic maintenance schedule for tool. When cleaning a tool be careful not to disassemble any portion of the tool since internal wires may be misplaced or pinched or may be improperly mounted. Certain cleaning agents such as gasoline, carbon tetrachloride, ammonia, etc. may damage plastic parts.
Intended Use
This tool is intended for accurate transfer of plumb point from floor to ceiling.
Preparation
Inserting/Replacing the Battery
Alkaline batteries are recommended for the tool.
To open the battery compartment 3, turn the latch 2 in clockwise direction to position 
and pull off the battery lid. Insert the batteries provided.
When inserting, pay attention to the correct polarity according to the representation on the inside of the battery compartment.
Position the battery lid to the bottom of the housing and then push it upward. To lock the battery lid, turn the latch 2 in counterclockwise direction to the 
position.
When the laser beams flash slowly during operation,the batteries are low. When the flashing begins, the tool can be operated for approx. 8 h.
Always replace all batteries at the same time. Only use batteries from one brand and with the identical capacity.
!Remove the batteries from WARNING the tool when not using
it for extended periods. When storing for extended periods, the batteries can corrode and discharge themselves.
Features
The numbering of the product features shown refers to the illustration of the tool on the graphic page.
1Exit opening for laser beam
2 Latch of battery lid
3 Battery lid
4 On/Off switch
5 Laser warning label
6 Tripod mount 1/4”
7 Serial number
8
9 Locking screw for
10Screw holes of
11Opening for strap attachment
12Magnets
131/4” tripod mount on
145/8” tripod mount on
15Laser Target*
16Belt Pouch*
17Laser viewing glasses*
18Tripod*
*The accessories illustrated or described are not included as standard delivery.
