Applications

Plumbing a surface

1.Position tool close to the surface to be plumbed.

2.Turn on tool.

3.Measure distance A at a point relatively close to tool and make a note of the distance.

4.Measure distance B at a point further away from tool and make a note of the distance.

Note: The greater the distance between the two points of measurement, the greater

the accuracy.

5.Compare distance A with distance B. If distance A equals distance B, then the surface is plumb. If distance A does not equal distance B, then the surface is not plumb and should be corrected.

Plumb

B

A

Transferring points with the plumb beam

1.Mark the point to be transferred (labeled A in this illustration).

2.Use the Mounting accessory or a Tripod to position the plumb down beam over point A.

3.The plumb up beam will transfer this point along a perfectly vertical axis to point B.

4.Mark point B.

Note: This process may be reversed.

Plumb Transfer

B

A

Use with Attachments

To fasten the tool on the Multiple-Purpose Attachment 8, screw the locking screw 9 of the Multiple-Purpose Attachment into the 1/4” tripod mount 6 on the tool and tighten. To rotate the tool on the Multiple-Purpose Attachment, slightly loosen the screw 9.

Rotate the tool on the Multiple-Purpose Attachment 8 sideward or toward the rear to make the bottom plumb beam visible.

Rotate the tool on the Multiple-Purpose Attachment 8 to project heights with the horizontal laser beam.

With the Multiple-Purpose Attachment 8, the tool can be attached as follows:

Mount the Multiple-Purpose Attachment 8 to a commercially available camera tripod

via the 1/4” tripod mount 13. For fastening to a commercially available construction tripod, use the 5/8” tripod mount 14.

The Multiple-Purpose Attachment 8 can be fastened to steel parts via the magnets 12.

The Multiple-Purpose Attachment 8 can be fastened to drywall or wood walls with screws. For this, insert screws with a minimum length of 2 in. into the screw holes 10 of the Multiple-Purpose Attachment.

The Multiple-Purpose Attachment 8 can also be fastened to pipes or similar beams using a commercially available strap by threading it through the opening 11 for strap attachment.

Working with the Tripod

(Optional Accessory)

A tripod 18 offers a stable, height-adjustable measuring support. Place the tool via the tripod mount 6 onto the 1/4” male thread of the tripod and screw the locking screw of the tripod tight.

-9-

Page 9
Image 9
Bosch Power Tools GPL2 manual Applications, Use with Attachments