Switching On and Off
To switch on the tool, press the On/Off button 15. Immediately after switching on, the tool sends a laser beam out of the exit opening 9.
•Do not point the laser beam at persons or animals and do not look into the laser beam yourself, not even from a large distance.
To switch off the tool, press the On/Off button 15 again.
•Do not leave the switched on tool unattendedand switch the tool off after use. Other persons could be blinded by the laser beam.
Leveling Functions
Note: The specified leveling accuracy applies for the alignment of the laser beam with reference to the spirit levels 6 and 7.
Positioning the Tool (see figure A)
For precise alignment with the spirit levels, the position of the tool is important.
The specified leveling accuracy is only achieved when the tool is correctly positioned:
•For horizontal alignment with the spirit level 7, the aluminium supporting surface 8 of the tool must face downward.
•For vertical alignment with the spirit level 6, the exit opening for the laser beam 9 must face upward.
Aligning with the Laser Line
Horizontal Alignment (see figures B and C): Position the tool with the three supporting points 12 against the wall or with help of the magnets 14, fasten it to the wall holder 1 or to another magnetic surface. The aluminium supporting surface 8 of the tool must face downward. Align the tool horizontally with help of the spirit level 7. Picture frames or tiles, as an example, can be aligned alongside the horizontal laser line.
Vertical Alignment (see figure C): Position the tool with the three supporting points 12 against the wall or with help of the magnets 14, fasten it to the wall holder 1 or to another magnetic surface. The exit opening for the laser beam 9 must face upward. Align the tool vertically with help of the spirit level 6. Top and bottom cabinets, as an example, can be aligned alongside the vertical laser line.
Alignment off of Reference Points (see figure D): Position the tool with the three supporting points 12 against the wall or with help of the magnets 14, fasten it to the wall holder 1 or to another magnetic surface. Turn the tool to any angle in order to
