Intended Use
The tool is intended for determining and indicating exact horizontal and vertical lines. It is also suitable for checking plumb lines and horizontal partitions or surfaces.
The tool is suitable exclusively for operation in enclosed
working sites.
Preparation
Inserting/Replacing the Battery
Use only
To open the battery lid 11, press the latch 10 in the direction of the arrow and remove the battery lid. Insert the batteries provided. Pay attention to the correct polarity of the batteries according to the representation in the battery compartment.
Always replace all batteries at the same time. Only use batteries from one brand and with the identical capacity.
•Remove the batteries from the tool when not using
it for extended periods. When storing for extended periods, the batteries can corrode and discharge themselves.
Features
The numbering of the product features shown refers to the illustration of the tool on the graphic page.
1Wall holder
2Pin
3Metal plate of the wall holder
4Adhesive tape strip*
5Belt clip
6Spirit level for vertical alignment
7Spirit level for horizontal alignment
8Aluminium supporting surface
9Exit opening for laser beam
10Latch of battery lid
11Battery lid
12Supporting points
13Laser warning label
14Magnets
15On/Off switch
*Accessories shown or described are not part of the standard delivery.
