BM 2610008439
TO LOCK TRIGGER "ON": squeeze trigger, depress button and release trigger.
TO UNLOCK THE TRIGGER: squeeze trigger and release it without depressing the "Lock- ON" button.
!WARNING If the
the trigger can not be released.
CONSTANT RESPONSE CIRCUITRy The internal electronic feedback system provides a "soft start", which will reduce the stresses that occur from a high torque start. The system also maintains the selected speed under load for maximum efficiency.
BLADE ORBIT SELECTOR LEVER
Maximum cutting efficiency can be obtained by adjusting the blade orbit selector lever to suit the material being cut.
The following chart will help you determine which setting to use for your application. This chart is intended as a guideline only, and test cuts in scrap material should be performed first to determine the best setting.
Setting O
Hard materials such as metals or thin sheet metals. This setting can be used with knife blades, grit edge blades,
rasp work and down cutting blades.
Setting I
Soft materials where cleaner cutting or delicate scrolling work is performed.
Setting II
Medium density materials such as harder woods or particle board.
Setting III
Soft materials such as wood, plastics, etc. and when fast cutting is more important than a clean cut.
CHIP BLOWER
Your jigsaw is equipped with a two position chip blower to help keep the cutting line clear of chips.
By adjusting the chip blower lever the force of the discharge air may be altered as follows;
BLOWER SWITCHED ON For working with wood, plastic and similar materials that produce large amounts of sawdust.
BLOWER SWITCHED OFF For working with metals and when cooling agents are used, or with dust collection accessory.
FOOTPLATE ANGLE ADJUSTMENT
The footplate may be tilted to allow angle cuts up to 45° in either direction (Fig. 6).
To adjust footplate, remove dust shroud if used, loosen the footplate screw and slide the footplate slightly forward towards the back of tool, then rotate to desired angle (Fig. 6).
The detent slots will hold the footplate firmly at 0°, and there are additional position marks for 15°, 22.5° 30° and 45° angles. Intermediate angles may be set with a protractor (Fig. 6).
After positioning the footplate, securely tighten the footplate screw (Fig. 6).
| FIG. 6 |
BEVEL | BEVEL |
SCALE | SCALE |
| FOOTPLATE |
| SCREW |
| FOOTPLATE |
2
1
+/- 45°
