![](/images/new-backgrounds/1151207/15120721x1.webp)
BM 2610021505
BEVELING EDGES
The
Depending on required bevel width, use the corresponding
Groove to be used | Dimension a (mm) |
None | 0 – 4 |
Small | 2 – 6 |
Medium | 4 – 9 |
Large | 6 – 10 |
FIG. 9
45°
DELUxE GUIDE FENCE
The deluxe guide fence can be used to control the width of the cut or for simply providing added stability and protection when cutting materials that are up to
FIG. 10
9 mm max
82 | m |
| ||
m |
| m | ||
ax | ||||
|
|
Note: The deluxe fence must be attached to the left side of the tool. (Fig. 1).
Installing the deluxe guide fence: Place the wing knob through the appropriate hole in the guide bracket and screw into left side of the housing. Securely tighten wing knob. Setting the cutting width: Place wing knob through the left fence arm and slide along the guide bracket to the desired position. Securely
tighten wing knob. Be certain that the flat washer (supplied) is fitted between the bottom of the guide fence and wing knob or the guide fence is likely to slip.
Setting the cutting width: Loosen wing knob and using the width scale, slide the fence along the guide bracket to the desired position. Securely tighten wing knob (Fig. 1).
Setting the cutting angle: Loosen round knobs and pivot the fence to the desired position. Securely tighten round knobs (Fig. 1).
Note that the adjustable front shoe contains three chamfer
RABBETING DEPTH STOP
The optional rabbeting depth stop accessory (Fig. 1) allows the user to set any rabbeting depth from 0 to 5/16" (9 mm). For best results, it is important that the blade be properly aligned (See "BLADE ALIGNMENT"). The width of the rabbet is controlled by the width fence. The final depth is achieved by repetitive cutting until the rabbeting depth guide contacts the workpiece. The maximum rabbeting depth is 5/16" (9 mm).
Setting the rabbet depth: Loosen wing knob and using the depth scale on the rabbeting depth stop, set the desired rabbet depth. Securely tighten wing knob (Fig. 1).