2610031969
Assembly
Disconnect battery pack ! WARNING from tool before making
any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
INSERTING BITS (Model PS32 only)
Move reverse switch lever to the center “OFF” position. Remove battery pack and rotate the clutch ring to the drill bit symbol
“
”. Rotate the chuck sleeve counter- clockwise viewing from chuck end, and open chuck to approximate drill bit diameter. Insert a clean bit up to the drill bit flutes for small bits, or as far as it will go for large bits. Close chuck by rotating the chuck sleeve clockwise and securely tighten by hand (Fig. 3).
Do not use the power of the ! WARNING drill while grasping chuck
to loosen or tighten bit. Friction burn or hand injury is possible if attempting to grasp the spinning chuck.
FIG. 3 | CHUCK SLEEVE |
| |
DRILL BIT |
|
BIT HOLDER
SCREWDRIVER BIT |
The Bosch model PS22 Cordless Drill/Driver has a chuck that accepts any 1/4" hex bit.
INSERTING AND REMOVING ACCESSORIES
(Model PS22 only)
To avoid loss of control, ensure bit is locked in chuck
by pulling on bit after it has been inserted.
To insert an accessory, simply pull locking sleeve forward, insert desired accessory into chuck until the locking sleeve retracts automatically, locking the bit (Fig. 2).
To remove an accessory, pull locking sleeve forward and simply remove it from the chuck.
One inch bits should only be used along with a bit holder as shown in figure 2.
FIG. 4
LOCKING
SLEEVE
DRILL BIT
SCREWDRIVER | CHUCK |
BIT |
|
| BIT HOLDER |
BELT CLIP AND BIT TIP HOLDER”
Both the PS22 and PS32 come with the option of a metal belt clip and a four piece bit tip holder.
BELT CLIP
When the tool is attached to ! WARNING the belt, position yourself to
avoid entanglement with surrounding objects. Unexpected entanglement could cause the tool to fall resulting in injury to the operator or bystanders.
The belt clip will allow you to conveniently attach your tool to your belt. This feature will allow you to have both hands free when climbing a ladder or moving to another work area.
The belt clip can be attached to either side of the tool by securing it with a mounting screw. Always make sure you securely tighten the mounting screw before use (Fig. 5).
To use clip, turn tool upside down and attach to your belt.
