BM 2609140575
Assembly
Disconnect battery pack ! WARNING from tool or place the switch
in the locked or off position before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
INSTALLING AND REMOVING
ACCESSORIES
1.To install accessories, align holes in accessory with locating pins on accessory holder in desired position. Assure that pin in holder are engaged into holes in accessory and securely tighten with with hex bolt provided (Fig. 1).
Your accessories can be engaged into accessory holder 12 positions 30 degrees apart.
For intermediate position an adapter is provided that will allow you to attach the accessory in any position. Use of adapter will
also allow you to use most competitor accessories.
2.To remove accessory, loosen and remove hex bolt and remove accessory from holder (Fig. 1).
INSTALLING SANDING SHEETS
Your tool uses
To change, merely peel off the old sandpaper, remove dust from the backing pad if necessary, and press the new sandpaper in place (Fig. 1).
After considerable use the backing pad surface will become worn, and the backing pad must be replaced when it no longer offers a firm grip. If you are experiencing premature wear of the backing pad facing, decrease the amount of pressure you are applying during operation of the tool.
Operating Instructions
SLIDE "ON/OFF" SWITCH
The tool is switched "ON" by the slide switch located on the topside of the motor housing (Fig. 1).
TO TURN THE TOOL "ON" slide the switch button forward to the “I” .
TO TURN THE TOOL "OFF" slide the switch button backward the “0” .
! WARNING | Hold the tool with both hands |
| while starting the tool, since |
|
torque from the motor can cause the tool to twist.
VARIABLE SPEED DIAL
This tool is equipped with a variable speed dial. The speed may be controlled during operation by presetting the dial in any one of six positions (Fig. 1).
BATTERY CHARGE CONDITION
INDICATOR LIGHTS
Your tool is equipped with charge condition indicator lights (Fig. 1). The indicator lights shows the charge condition of the battery during operation.
For safety reasons, only check the charge condition when the tool is at a complete standstill.
To check the charge condition, press and hold the charge condition indicator button with the tool in the off position.
LED | Capacity |
Continuous lighting 3 x green | 2/3 |
Continuous lighting 2 x green | 1/3 |
Continuous lighting 1 x green | 1/3 |
Flashing light 1 x green | reserve |
|
|
APPLICATION
Your tool is intended for sawing and separating wooden materials, plastic, plaster,
as well as for working on soft wall tiles and for dry sanding and scraping of small surfaces. It is especially suitable for working close to edges and for flush cutting.
