Yard Machines MTD27P manual Assembly Instructions, Debris Shield Installation, Assist Handle, Bolt

ASSEMBLY INSTRUCTIONS

NOTE: The only assembly required for your trimmer is to install the debris shield and the assist handle.

DEBRIS SHIELD INSTALLATION

1.Position the motor housing with stringhead carrier fac- ing up (Figure 1).

2.Slide debris shield over motor housing as shown (Figure 2).

3.Align edging guide with mating grooves and push firm- ly in the direction shown until an audible snap is heard (Figure 3).

NOTE: Be certain that edging guide is oriented as shown. Once edging guide, motor housing and debris shield are mated the connection is permanent and cannot be removed without a special tool.

ATTACH ASSIST HANDLE (Fig. 4 and Fig. 5)

1.Insert the handle in comfortable position and tighten securely.

2.Before tightening completely, adjust the assist handle height by sliding handle up or down tube. When assist handle is at desired operating height, tighten it secure- ly.

Assist Handle

Nut	Bolt
	Fig. 4

Fig. 1

Fig. 5

Fig. 2

Fig. 3

7