BM 1619929E58
FIG. 9
AUxILIARy HANDLE
The tool must be supported with the auxiliary handle, which can be swiveled 360˚. To reposition and/or swivel the handle, loosen the hand grip, move the handle to the desired position along the barrel and securely retighten the hand grip (Fig. 9).
HAND GRIP
DEPTH GAUGE
Your drilling depth can be
Setting depth: After the auxiliary handle is installed, make sure the accessory has been fully inserted into the tool holder before setting the depth gauge (Fig. 10).
To adjust depth, push the depth gauge release button, slide the depth gauge to desired depth and release pressure on button to lock the depth gauge in place.
FIG. 10
DEPTH GAUGE |
RELEASE BUTTON |
DEPTH GAUGE |
X
Operating Instructions
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed trigger switch. The tool can be turned "ON" or "OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum to maximum nameplate RPM by the pressure you apply to the trigger. Apply more pressure to increase the speed and release pressure to decrease speed (Fig. 1).
FORWARD/REVERSE SWITCH
The reversing switch is used to reverse rotation of the bit (Fig. 1).
The reversing switch should ! CAUTION only be activated when the
motor is "OFF" and when bit is at a complete standstill.
To use tool in "Forward" rotation move switch
torward the arrow 
that depicts forward.
"Reverse" the rotation of the bit move the
switch torward arrow 
that depicts reverse.
