Bosch Power Tools RHH181BL, RHH181-01 Assembly, Installing SDS-plusACCESSORIES, Locking Sleeve

FIG. 4

! WARNING

FIG. 2

1

! WARNING

! WARNING

BM 2610034452 03-14_RHH181 3/27/14 12:35 PM Page 8

Assembly

Disconnect battery pack from tool or place the switch in the locked or off position before

making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.

INSTALLING SDS-plus®ACCESSORIES

Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant

Insert accessory into the chuck through the dust shield, while twisting and pushing inward until it locks automatically into place. Pull outward on the accessory to be certain it is locked into the chuck (Fig. 2).

NOTE: The high efficiency available from the rotary hammers can only be obtained if sharp and undamaged accessories are used. The "cost" to maintain sharp and undamaged accessories is more than offset by the "time saved" in operating the tool with sharp accessories.

REMOVING SDS-plus®ACCESSORIES Accessories may be hot after use. Avoid contact with skin

and use proper protective gloves or cloth to remove.

To remove an accessory, pull locking sleeve backward and pull bit forward. All accessories should be wiped clean after removing (Fig. 3).

3

2

DUST	FIG. 3
SHIELD

LOCKING

SLEEVE 1

2

Disconnect battery pack from tool or place the switch in the locked or off position before

making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.

until it locks automatically into place. Pull outward on the accessory to be certain it is locked into the chuck (Fig. 5).

To remove the chuck, pull the locking sleeve backward (towards the rear of tool), while pulling the chuck forward.

INSTALLING & REMOVING 3-JAW CHUCK

(Not included, available as accessory) The 3 Jaw Chuck with SDS Shank can convert your

tool for use with straight shank bits (Fig. 4).

FIG. 5

3-JAW CHUCK

(Not included, available

as accessory) 3

Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant

Insert accessory into the chuck through the dust shield, while twisting and pushing inward

1

2 LOCKING SLEEVE

-8-