Bosch Power Tools ROTOZIP RZ18V Depth Guide Adjustment, Releasing and Inserting Battery Pack

RZ 2610925600 9-05 9/1/05 11:04 AM Page 13

DEPTH GUIDE ADJUSTMENT

Use the depth guide to adjust the depth of cut. Using the end of the standard wrench, loosen (counter clockwise) the screw enough to enable the depth guide to slide up or down to the desired depth of cut (about 1/8" greater than material thickness) and retighten the locking screw (clockwise) (Fig. 7).

FIG. 7

DEPTH GUIDE

LOCKING

SCREW

1/8"

RELEASING AND INSERTING BATTERY PACK

Release battery pack from tool by pressing on both sides of the battery release tabs and pull downwards. Before inserting battery pack, remove protective cap from battery pack. To

insert battery, align battery and slide battery pack into tool until it locks into position. Do not force.

CHARGING BATTERY PACK (30 MINUTE SINGLE BAY-BC130)

INDICATORS, SYMBOLS AND MEANING If the indicator lights are “OFF”, the charger is not receiving power from power supply outlet.

If the green indicator light is “ON”, the charger is plugged in but the battery pack is not inserted, or the battery pack is fully charged

and is being trickle charged.

If the green indicator light is

“BLINKING”, the battery pack is being fast-charged. Fast- charging will automatically stop when the

battery pack is fully charged.

If the red indicator light is “ON”, the battery pack is too hot or cold for fast-charging. The charger will switch to trickle charge, until a

suitable temperature is reached, at which time the charger will switch automatically to fast-charging.

If the red indicator light is

“BLINKING”, the battery pack cannot accept a charge or the contacts of the charger or battery pack are

contaminated. Clean the contacts of the charger or battery pack only as directed in these operating instructions or those supplied with your tool or battery pack.

Plug charger cord into your standard power outlet. Before inserting battery pack, remove protective cap, then insert battery pack into charger (Fig. 8).

The charger’s green indicator light will begin to “BLINK”. This indicates that the battery is receiving a fast charge. Fast-charging will automatically stop when the battery pack is fully charged.

When the indicator light stops “BLINKING” (and becomes a steady green light) fast charging is complete.

The battery pack may be used even though the light may still be blinking. The light may

require more time to stop blinking depending on temperature. When you begin the charging process of the battery pack, a steady red light could also mean the battery pack is too hot or too cold.

The purpose of the green light is to indicate that the battery pack is fast-charging. It does not indicate the exact point of full charge. The light will stop blinking in less time if the battery pack was not completely discharged.

When charging several batteries in sequence, the charge time may slightly increase.

-13-