14
OPERATION
Tab 3, 11
Tab 8, 16 Tab 7, 15 Tab 6, 14 Tab 5, 13 Tab 4, 12 EnglishTab2 , 10
Control buttons
The control buttons are located on the top of
the speaker.
Pairing with Bluetooth® devices
Pairing occurs when two Bluetooth devices
communicate with each other and establish a
connection. A record of information about this
connection is then stored in the memory of
each device. Once you pair a device with the
SoundLink® Mobile speaker II, you should not
have to pair it again.
The SoundLink® Mobile speaker II can pair
with up to six Bluetooth devices. However, it
can only connect to, and play audio from one
device at a time.
• Press to turn the speaker on or off.
• Press and hold to check the battery level
(see “Checking the battery” on page18).
• Press to select the source connected to the
(AUX) input. See “Adding another
source” on page16 .
• Press to select the Bluetooth® source. The
speaker attempts to connect to the last
paired device. See “Pairing with Bluetooth®
devices.”
• Press and hold for 3 seconds to set the
speaker to discoverable mode and allow
pairing with another Bluetooth® device.
• When a device is connected, press to
disconnect the device. The speaker then
waits for a paired device to connect.
• While the Bluetooth® source is selected, if
no device connects within 30 minutes, the
speaker turns itself off.
• Mutes sound from the speaker.
• Plus (+) increases volume, minus (–)
decreases volume. The front panel source
indicator flashes once for each button press.
The indicator flashes twice when maximum
or minimum volume is reached.
Bruiser_OG.book Page 14 Tuesday, June 26, 2012 10:29 AM