TANDBERG 880, 990, 770 user manual Wireless LAN Settings

TANDBERG Videoconferencing System Advanced use

Wireless LAN Settings

SSID (Service Set Identification)

Example “WLANNETWORK”. Defines a local network id for this wireless region. It must be the same for all end points and the access point. An endpoint will find the access point if the SSID is correct, however if the encryption key is faulty it will not transmit any data.

Community (optional)

Community can be used when connecting to an access point where the SSID is the same. Example “Unit2”.

WLAN Mode
AdHoc:	Used when not communicating with an access point.
Managed:	Used when communication is made through an access point.

Restart

Make sure the corresponding settings are programmed into the access point. Press “Restart” in order to activate the settings.

Required cards

•Compaq WL110 11 Mbps Wireless LAN

•Lucent Orinoco 11 Mbit/s SILVER

•Lucent Orinoco 11 Mbit/s GOLD

•Cisco Aironet 350 series (AIR-PCM 350 series)

•Enterasys Networks RoamAbout 802.11 DS High Rate

•Melco Buffalo WLI-PCM-L11G

Recommended access point

• Compaq WL410 base station

NOTE

THE PC CARD/PCMCIA-CARD USED MUST COMPLY WITH THE RELEVANT REGULATIONS FOR SUCH CARDS IN THE COUNTRY WHERE IT IS USED.THE UNIT MUST BE SUPPLIED BY POWER SUPPLY (AC-DCADAPTER) POWERBOX SPN-270-12,WHICH COMPLIES WITH THE REQUIREMENTS FOR LIMITED POWER SOURCE ACCORDING TO IEC/EN 60950

79