TANDBERG 880, 990, 770 ISDN cables, Power cable, 5a. LAN cable, 5b. Wireless LAN - Insert PC Card

TANDBERG Videoconferencing System Installation

3. ISDN cables

•CConnect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service provider. Your main number will be the number associated with the socket to which ISDN cable number 1 is connected.

NOTE

SOME SYSTEMS AND SOFTWARE VERSIONS DO NOT SUPPORT THREE ISDN LINES

North America: The system does not have a built-in network terminator. If your wall socket provides you with an ISDN U-interface, you will need an NT1 between your system and your ISDN line, see Appendix 1.

NOTE WRITE DOWN THE NUMBERS ASSOCIATED WITH EACH OF THE ISDN LINES. YOU WILL NEED THEM LATER TO CONFIGURE THE SYSTEM.

NOTE CONNECTING TO THE SWITCHED 56 NETWORK: WHEN CONNECTING TO THE SWITCHED 56 NETWORK YOU MAY USE ONE OF THE BRI INTERFACES ON THE SYSTEM. PLEASE REFER TO APPENDIX 2 FOR FURTHER INFORMATION.

4. Power cable

• Connect the power cable from the system’s power connector to an electrical distribution socket.

5a. LAN cable

• To use the system on LAN, connect a LAN cable from the ‘Ethernet’ connector on the system to your LAN.

5b. Wireless LAN - Insert PC Card

•Remove the “dummy” card by pressing the ‘Eject’ button next to the slot.

•Insert the Wireless LAN PC Card.

NOTE

MAKE SURE YOU INSERT THE CARD IN THE RIGHT DIRECTION (WITH THE PRODUCT LOGO POINTING UPWARDS). PUSH THE CARD INTO THE SLOT UNTIL THE ‘EJECT’ BUTTON POPS UP.

See ‘Wireless LAN Settings’ for configuration.

13