6
English
Connecting the VS-2 to Your Media Center

Preparation

When setting up a LIFESTYLE® system with the VS-2, the media center
power supply plugs into the VS-2 instead of the media center.
•If you are setting up the VS-2 and your LIFESTYLE® system at the
same time, find the media center power supply in the LIFESTYLE
system carton before you begin.
•If you are adding the VS-2 to an existing LIFESTYLE® system, turn
off your LIFESTYLE system, wait 30 seconds, and unplug the media
center power supply from the wall outlet. Then, disconnect the power
supply from the rear panel of the media center. Also, remove any video
cables from the Video OUT and Video IN connectors on the media center.

Connecting the VS-2 to your media center

VS-2 cable
VS-2 end panel
Media center power supply
Media center rear panel
WARNING: The VS-2 must be used only with the media center power supply
that came with your LIFESTYLE® DVD home entertainment system.
234
1
5
6
7
• Connect the 4-connector en d of the VS-2 cable to your media center:
1Insert the Serial Data plug into the Serial Data connector.
2Insert the DC Power plug into the DC Power connector.
3Insert the Composite plug into the Composite Video OUT connector.
4Insert the S-Video plug into the S-Video OUT connector.
• Connect the other end of t he VS-2 cable to the VS-2 end panel:
5Insert multi-pin plug into the Media Center connector.
6Insert the DC Power plug into the DC POWER Out connector.
• Connect the media cente r power supply to the end panel of the VS-2:
7Insert the DC power cable from the media center power supply into the
DC POWER In connector.
Note: Straighten the DC power cord from the media center power supply and
from the VS-2 to the media center as much as possible. This cord is used as
the antenna for your LIFESTYLE® system remote control.
00_LasikOG.book Page 6 Thursday, October 26, 2006 1:23 PM