Bose II Using the Bose Aviation Headset, Panel Hole Required, Receptacle - Pinout Front View

Models: II

1 28

Page 16

Using the Bose® Aviation Headset

5.Approved adhesives for use with this connector are Ciba-Geigy Uralane 5754- A/B, Lord 710, or VTCS-6 Vibratite. Do not let any cyanoacrylate-based adhesives (e.g., Loctite), flux remover, or other caustic compounds come into contact with the installed connector body. These chemicals will cause deterioration and/or irreparable damage to the connector. For information on chemical compatibility and connector part number, contact LEMO USA, Santa Rosa, CA at 1-800-444-5366.

PANEL HOLE REQUIRED

Figure 9

12.6mm

Connector technical .5" information

14.1mm

.56"

RECEPTACLE - PINOUT (FRONT VIEW)

PIN 1

PIN 6

AIRCRAFT INTERFACE SCHEMATIC

RED

BLK

WHT

BLK

WHT

WH/BLU

BLK

•

1V+IN

2GND

3COMM L

4COMM R

5MIC HI

6MIC LO

Page 16

Image 16

Bose II Using the Bose Aviation Headset, Panel Hole Required, Receptacle - Pinout Front View, Aircraft Interface Schematic

Contents

Bose Aviation Headset Series Owners GuideOperational Advisories Operational Advisories The wearer should ensure thatDeclaration of Conformity Operational AdvisoriesContents Description Warranty cardIntroduction Using the Bose Aviation Headset For proper headset fitInterconnect plug Microphone placementUsing the Bose Aviation Headset Adjusting the volume Note The volume cannot be turned off completelyFail-resistantoperation Using the Bose Aviation HeadsetMicrophone boom relocation Using the Bose Aviation HeadsetHeadset cable relocation Using the Bose Aviation HeadsetPowering the headset Portable battery packCharging the NICAD battery pack The NICAD rechargeable battery packseat them securely Using the Bose Aviation HeadsetSpin the batteries once with thumb to Click Using the Bose Aviation HeadsetClick Installed connector Installing the wire harnessUsing the Bose Aviation Headset WireUsing the Bose Aviation Headset AIRCRAFT INTERFACE SCHEMATICPANEL HOLE REQUIRED RECEPTACLE - PINOUT FRONT VIEWInstalling the DC power connector Installed DC power connectorUsing the Bose Aviation Headset Cleaning instructions Care and MaintenanceCAUTION Do not immerse the headset in water To remove the cushion and foam linerTo install a new foam liner To clean the cushionTo replace the cushion Care and MaintenanceIn Case of Difficulty ProblemWhat to do Technical Information Bias RequiredSensitivity Active Noise Reduction Bandwidth 30Hz - 700HzOperating Temperature Storage TemperatureAltitude Headset WeightService Warranty periodService and Warranty Information If your headset must be returned for serviceLimited warranty Bose product What is coveredFor how long What we will doPage Page