138
Chapter 8 Parameters Guide
Display of Parameters You Can Set with SYS KNOB SETTING
The parameter names displayed in the Play screen (p. 25) are
abbreviated. For details about the parameter names, refer to
the chart shown below.
EXP PEDAL SW SETTNG (Expression Pedal Switch
Setting)
CTL1–4 PEDAL SETTING (CTL1–4 Pedal Setting)
Prefernc (Preference)
Patch
The patch pedal setting is used. This allows
you to use different pedal settings in each
individual patch.
System
The CONTROLLER screen’s pedal setting
(Function, Min, Max and Src Mode) is used.
This applies the same pedal settings to all
patches.
Function
Off The function is not assign to the pedals.
Ch. A/B Switches between effect channel A and B.
Comp Switches the COMP on and off.
OD/DS Switches the OD/DS on and off.
Preamp Switches the PREAMP/SPEAKER on and
off.
EQ Switches the EQ on and off.
FX-1 Switches the FX-1 on and off.
FX-2 Switches the FX-2 on and off.
Delay Switches the DELAY on and off.
Chorus Switches the CHORUS on and off.
Reverb Switches the REVERB on and off.
Pedal FX Switches the PEDAL FX on and off.
Send/Return Switches the SEND/RETURN on and off.
Amp Ctl Switches the Amp Control on and off.
Tuner
Switches the TUNER on and off.
Manual Switches the MANUAL MODE on and off.
PL Switches the PHRASE LOOP on and off.
PL Rec/Play Records/plays back the phrase.
PL Clear Clears the phrase.
PL Mute/Ply Mutes playback of the phrase.
BPM Tap Used for tap input of the Master BPM.
Delay Tap Used for tap input of the delay time.
MIDI Start Controls the Start/Stop of external MIDI
devices (such as sequencers).
MMC Play Controls the Play/Stop of external MIDI
devices (such as hard disk recorders).
Lev +10 Increases the patch volume level by 10
units.
Lev +20 Increases the patch volume level by 20
units.
Lev -10 Decreases the patch volume level by 10
units.
Lev -20 Decreases the patch volume level by 20
units.
Num Inc
Switches to the next higher patch number
in the same bank as the currently selected
patch.
Num Dec
Switches to the next lower patch number in
the same bank as the currently selected
patch.
Bank Inc Switches to the next higher bank number.
Bank Dec Switches to the next lower bank number.
Parameter/
Range
Explanation
Min (Minimum)
Off, On This sets the value for times when the
switch is Off.
Max (Maximum)
Off, On This sets the value for times when the
switch is On.
Src Mode (Source Mode)
This sets the behavior of the value each time the switch is operation.
Moment
The normal state is Off (minimum value),
with the switch On (maximum value) only
while the footswitch is depressed.
Toggle
The setting is toggled On (maximum value)
or Off (minimum value) with each press of
the footswitch.
Display with SYS
KNOB SETTING
Display at Play
screen 1
Display at the
bottom of the
Play screen
COMP:CS:Sus COMP CS SUS CS SUS
COMP:CS:Atk COMP CS ATK CS ATK
COMP:LM:Thres COMP LM THR LM THR
COMP:LM:Rel COMP LM REL LM REL
COMP:MB:LoThr COMP MB LTH MB LTH
COMP:MB:HiThr COMP MB HTH MB HTH
COMP:NA:Drive COMP NA DRV NA DRV
COMP:Tone COMP TONE CS TNE
COMP:Level COMP LEVEL CS LEV
ODDS:Drive ODDS DRIVE OD DRV
ODDS:Tone ODDS TONE OD TNE
ODDS:EfectLev ODDS E LEV OD ELV
PRE:Gain PRE GAIN PreGAN
PRE:Level PRE LEVEL PreLEV
PRE:Bass PRE BASS PreBAS
PRE:Mid PRE MID PreMID
PRE:Treble PRE TREBL PreTRB
PRE:Presnce PRE PRES PrePRS
PRE:Mic Lev PRE M LEV PreMLV
EQ:Low Cut EQ L CUT EQ LC
EQ:Low Gain EQ LOW EQ LOW
EQ:Lo-MidGain EQ L MID EQ LMD
EQ:Hi-MidGain EQ H MID EQ HMD
EQ:High Gain EQ HIGH EQ HI
EQ:High Cut EQ H CUT EQ HC
DELAY:Time DELAY TIME DD TIM
DELAY:Feedbak DELAY FBK DD FBK
DELAY:Hi Cut DELAY H CUT DD HC
DELAY:EfctLev DELAY E LEV DD ELV
Parameter/
Range
Explanation
GT-10B_e.book 138 ページ ２００８年２月２６日　火曜日　午後３時３０分