33
Chapter

2

Chapter 2 Creating Sounds (Patch Edit)
If you already have a clear idea about the kind of sound you want to create, you can save yourself a lot of trouble by starting out
with a patch that is relatively similar to what you have in mind, then tweak its settings until you arrive at what you want.
EZ TONE CREATE lets you create sounds easily by choosing settings close to the musical genre and the feel of the song you want
to compose.
The current settings for the patch you are using at the moment are lost when you press EZ TONE [CREATE]. If you want to save the current settings, carry out the
Write procedure (p. 43) before performing the procedure below.
By using EZ TONE EDIT you can adjust the sound of a patch with ease, without having to manipulate complicated parameters.

Creating Sounds with Ease (EZ TONE)

Creating a Tone for the Song You Envision (Create)

1.
The TONE screen for EZ TONE CREATE appears.
2.
P1, P2 knob: This selects the basic tone.
P3, P4 knob: This selects a variation.
3.
The DRIVE Tone Grid for EZ TONE CREATE appears.
4.
P1, P2 knob: This adjusts the distortion and the
compression effect.
P3, P4 knob: This adjusts the tone.
Switching patches causes all settings that have been made to be lost.
To save the sound you’ve created, carry out a Write operation (p. 43).
You can take parameters you��ve adjusted with EZ TONE CREATE and
fine-tune them further using EZ TONE EDIT or parameter operations. For
more information, refer to “Adjusting the Tone (Edit)” (p. 33).

Adjusting the Tone (Edit)

1.
The EZ TONE EDIT screen appears.
2.
P1 knob: Adjusts the volume level of the compressor.
P2 knob: Adjusts the distortion (DRIVE).
P3 knob: Adjusts the volume level of the chorus.
P4 knob: Adjusts the volume level of the reverb.
Adjusts the volume level of the Ch.A compressor.
Adjusts the volume level of the Ch.A chorus.
Adjusts the volume level of the Ch.B reverb.
Adjusts the distortion (DRIVE) of the Ch.B.
GT-10B_e.book 33 ページ ２００８年２月２６日　火曜日　午後３時３０分