Installing/Replacing the Battery (continued)
4 |
|
| 5 |
|
|
| 6 |
|
|
| E |
|
|
|
|
|
|
| S |
|
|
| S |
|
|
| LO |
|
|
| |
|
|
|
|
|
|
| E |
E |
|
| C |
|
|
| LO |
S |
|
| N |
|
| EN | C |
O |
| PE |
|
|
| ||
CL | O |
| O | P |
| ||
|
|
| |||||
| PENO |
|
|
|
|
|
|
Warning: Always use the rubber ring 
when installing the
battery cover.
7.Remote Cradle Mounting Instructions
There are 2 recommended mounting options:
1.If mounting the cradle on a wood surface, two self tapping stainless steel screws are included. Hold the cradle in place and proceed with the self tapping screws.
2.If mounting on the surface of a SPA, Boat or other fiberglass surface, we've included an adhesive strip that is resist to most SPA chemicals, saltwater and sunlight. Make sure the mounting surface is clean and dry. Then remove the adhesive proactive tape on both sides of the adhesive strip, and apply the strip to the fiberglass surface. You're now ready to mount the cradle. Simply press firmly for a few seconds and it's done. firmly for a few seconds and it's done.
M3X12mm
5. How to pair Remotes
Each receiver can support up to 10 Remote Controls at the same time.
Method: Press and hold the DISP button for 5 seconds.
Note: If the receiver is already paired with 10 remotes successfully and you continue to pair new remotes, it will automatically
6. Specifications
Remote Control Power: | 1 pcs CR2430 Battery |
RF Range: | Up to 20 Feet |
Remote Control | 86x 56x12 mm |
Dimensions (H x W x D): |
|
RF Receiver Dimensions | 76x 42x17 mm |
(H x W x D): |
|
Note: Specifications are typical. Individual units may vary. Specifications are subject to change and improvement without notice.
Reminder: This unit uses 433.92MHz and may interfere with other RF transmissions near this frequency.
