12
Turning the Power On/Off Turning On the Power
Insert the plug of the connection cable into the
OUTPUT jack.
* This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required before the
unit will operate normally.
Turning Off the Power
Remove the plug of the connection cable from
the OUTPUT jack.
Important <Note>
When turning on the power while a recorded track is being selected (the LOOP/ONE SHOT indicator is lit), the indicators
on the front panel flash in a sequential order, and the LOOP/ONE SHOT indicator flashes rapidly for a few seconds.
Turning off the power while the LOOP/ONE SHOT indicator is still flashing rapidly may result in the loss of all saved data.
Never turn off the power while the LOOP/ONE SHOT indicator is flashing rapidly.
To avoid problems, select an empty phrase track whenever possible before turning the power on/off.
■ Caution when turning off the power
Before you turn off the power (disconnect the plug from the OUTPUT jack), make sure that all of the following conditions
are satisfied.
All saved data may be lost if the power is turned off inappropriately.
● You must not be recording/playing/overdubbing a phrase
(The REC/PLAY/DUB indicators must not be lit)
● The MODE knob is set to either AUTO, , or
● The LOOP/ONE SHOT indicator is not flashing rapidly
RC-2_e.book 12 ページ ２００６年１０月２７日 金曜日 午前１０時３１分