LOADING THE N100S
EYE PROTECTION which conforms to ANSI specifications and provides protection against flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when loading, operating or servicing this tool. Eye protection is required to guard against flying fasteners and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment must conform to the requirements of the American National Standards Institute, ANSI
TO PREVENT ACCIDENTAL INJURIES:
•Never place a hand or any other part of the body in nail discharge area of tool while the air supply is connected.
•Never point the tool at anyone else.
•Never engage in horseplay.
•Never pull the trigger unless nose is directed at the work.
•Always handle the tool with care.
•Do not pull the trigger or depress the trip mechanism while loading the tool.
1.Open the magazine:
Pull pusher back to engage latch.
2.Load Nails:
Hold nailer down with magazine tilted downward. Insert sticks of nails
3. Close Magazine:
Release latch by pulling latch tab and pusher together slightly to disengage, slide pusher against nails.
NOTE: Use only nails recommended for use in Bostitch N100S series nailers or nails which meet the Bostitch specifications
