LOADING THE N88
EYE PROTECTION which conforms to ANSI specifications and provides protec- tion against flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when loading, operating or ser- vicing this tool. Eye protection is required to guard against flying fasteners and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment must conform to the requirements of the American National Standards Institute, ANSI
TO PREVENT ACCIDENTAL INJURIES:
•Never place a hand or any other part of the body in nail discharge area of tool while the air supply is connected.
•Never point the tool at anyone else.
•Never engage in horseplay.
•Never pull the trigger unless nose is directed at the work.
•Always handle the tool with care.
•Do not pull the trigger or depress the trip mechanism while loading the tool.
N88WW
1. Load nails. | 2. Pull pusher back all the way. |
3.Allow pusher spring to pull the pusher forward until it contacts the last nail.
N88RH
1. Open the magazine: | 2. Load Nails: | ||||||||
|
|
| Pull pusher back to | Hold nailer down with | |||||
|
|
|
| engage the latch. | magazine tilted downward. | ||||
|
|
|
|
|
|
|
|
| Insert stick of nails |
3. Close Magazine:
Release pusher by first pulling back on the pusher and then pressing the pusher release tab. Slide pusher against nails.
NOTE: Use only nails recommended for use in Bostitch N88 series nailers or nails which meet the Bostitch specifications.
