Boston Acoustics 9000, 9500 manual Line-LevelSystem Connection cont, Dolby Digital Systems

9000II_9500 manual rev2 7/16/01 3:42 PM Page 10

Dolby Pro Logic and Dolby Digital

Line-Level System Connection (cont.)

Dolby Digital Systems

The recommended wiring for all Dolby Digital receivers is to use both speaker wire and line-level connections to the subwoofer, as shown below. Use an RCA cable (not included) to connect your receiver’s Sub out or LFE out jack to the appropriate Line in jack on the subwoofer, as shown below. On your receiver’s set-up menu:

Select “LARGE” for the front left/right speakers.

Select “SMALL” for the center channel speaker and the rear surround speakers . Select “SUBWOOFER-YES”.

			Use either jack,
Receiver			depending on your receiver		Micro pv Subwoofer
			LFE out	Sub out		line level in
						from	from
						sub out	LFE out
	Surround	Center		Main
Left	speakers Right	speaker	Left	speakers	Right
					L	R
					Speaker level in

Left Micro90x II/80x II Right Micro90x II/80x II Left Micro90x II Right Micro90x II

Micro90c II

NOTE: It is also acceptable (though not optimal) to connect the subwoofer to the Dolby Digital receiver’s “Sub out” or “LFE out” without also using speaker wires. In this configuration, on your receiver’s set-up menu:

Select “SMALL” for the front left/right speakers.

Select “SMALL” for the center channel speaker and the rear surround speakers . Select “SUBWOOFER-YES”.

When using this configuration, refer to the Dolby Pro Logic wiring diagram shown on page 9.

10