9000II_9500 manual rev2 7/16/01 3:42 PM Page 14
The Micro90x II and Micro80x II satellites may be
1Install a #8 or #10 mounting screw on the wall (not
hardware to use on your wall surface).
2Attach the bracket to the back of the speaker with the machine screw and acorn nut as shown.
3 If you are running wires behind the wall, make a 3⁄8" (9.5mm) wire hole, 13⁄4" (44mm) below the mounting screw for the wire.
1
3
2
The speaker may be angled upward for optimum coverage of the listening area.
An optional pedestal shelf
Troubleshooting
Subwoofer does not make sound
1.Check to ensure the subwoofer’s AC power cord is properly plugged in. If the outlet being used is controlled by a switch, make sure the switch is on.
2.If the power cord is properly attached but the pilot light does not illuminate, the AC fuse may be blown. If necessary, replace the fuse with a
Listening Levels and Power Handling
The power recommendation for the speaker assumes the amplifier is not overdriven, which, over a long period, can damage even our rugged speakers. If you hear a harsh, gritty noise, turn down the volume control. Prolonged or repeated operation with a distorted signal from the amplifier can cause damage to the speakers, which is not covered by the warranty.
14