Boston Acoustics Center Channel Speaker manual Configuring the Boston Bravo Center to Your Setup

upper hole

lower hole

paper backing

1 1/2'' (38mm)￿ max

rotating mounting pad pre-installedself-adhesive strip

self-adhesive feet

Configuring the Boston Bravo Center to Your Setup

The Boston Bravo Center can be configured to accommodate any style of television and home theater arrangement. Take a minute to study the type of television that you have in order to determine which of the following configurations you should use.

Flat Top Placement

This is the simplest way to configure the speaker and should be used wherever possible. If you are placing the Boston Bravo Center on top of a rear projection TV or one with a large

flat top surface (six inches or more in depth), then you can use it just the way it comes out of the box. Use the four

self-adhesive rubber feet (provided) to protect the TV’s finish and reduce vibration. Peel off and apply a foot to each semi-circular pad located underneath the two front corners of the housing as shown. Apply the other two feet to the outer-

most corners of the rear support section on either side of the rotating mounting pad as shown. Alternatively, you may wish to secure the speaker to its surface by eliminating the rear feet and using the self-adhesive, pre-installed hook-and-loop strip instead (see illustration below).

Angled Top Placement

If your TV has a shallow top (less than six inches in depth) and angles downward in the back, then you should use the sliding rear stand to secure the back half of the speaker. First apply the two front

rubber feet as shown above (do not apply the rear feet). Loosen the knurled knob, move the slide

down and flip up the

rotating mounting pad. With the speaker

centered and in the

position that you want

it to stay in, move the

slide down until the mounting pad contacts the

angled surface of the TV. Pull off the

paper backing from the pre-attached, self-adhesive hook-and-loop strip and stick the mounting pad on the TV. Press down on the mounting pad to ensure that the two hook-and-loop halves are locked. Adjust the speaker to its

upright position and tighten the knob firmly. If you need to move the slide down more than one inch, then remove the knob from

the upper hole and screw it into the lower hole as shown to the

left. This will centralize the contact point of the slide and prevent any rattling that may occur at very loud volumes. It will also

double the adjustment depth to three inches.

3'' (76mm)￿ max

4