DSi450460480 10/25/01 1:05 PM Page 7
Tools You’ll Need
1.A utility knife, jig saw or other tool for cutting the required hole in the mount- ing surface.
2.A #2 Phillips screwdriver.
3.A wire cutter or stripper for preparing the speaker wires.
4.A pencil.
Retrofit Installations
1.Mark the outline of the installation hole using the supplied template. Make a small hole at the center of the speaker location. Insert a long, bent piece of wire and rotate to confirm that there are no obstructions behind the chosen location.
2.Cut the installation hole.
3.Run the wire from the amplifier location to the cutout. Allow for an extra foot of wire at the cutout.
Herramientas necesarias
1.Un navaja multiusos, una sierra caladora u otra her- ramienta para cortar el agu- jero adecuado en la superfi- cie de montaje.
2.Un destornillador de estrel- la o cruz del número 2.
3.Un cortador de alambre o un pelacables para preparar el cableado de los altavo- ces.
4.Un lápiz.
Instalaciones para el montaje trasero
1.Marque el contorno del agu- jero con la plantilla sumin- istrada. Haga un pequeño agujero en el centro de la ubicación del altavoz. Meta un alambre doblado y déle vueltas para asegurarse de que no hay obstáculos traseros en la posición elegi- da.
2.Corte el agujero para la insta- lación.
3.Tienda el cable desde el ampli- ficador hasta el hueco donde se ubicará al altavoz. Corte unos 30 cm más de lo nece- sario.
Outils nécessaires
1.Un couteau, une scie à découper ou tout autre outil capable de découper l’orifice nécessaire dans la surface de montage.
2.Un tournevis cruciforme No. 2.
3.Une pince coupante ou à dénuder pour préparer les fils des enceintes.
4.Un crayon noir
Installations améliorées
1.Tracez le contour de l’orifice d’installation en utilisant le gabarit fourni. Faites un petit trou au centre de l’en- droit où sera placée l’en- ceinte.
2.Découpez l’orifice d’instal- lation.
3.Amenez le câble de l’ampli à l’orifice que vous venez de découper, en prévoyant 30 cm de câble supplémen- taire.
Benötigte Werkzeuge
1.Ein Messer, eine Stichsäge oder anderes Werkzeug zum
2.Einen Kreuzschlitz- Schraubendreher, Größe 2.
3.Eine Drahtzange oder einen
Drahtstripper zur
Vorbereitung der Lautsprecherkabel.
4.Einen Bleistift.
Einbau in eine fertige Fläche
1. Den | Umriss | des | |
Installationslochs mit der mit- | |||
gelieferten Maske | anzeich- | ||
nen. In der Mitte der aus- | |||
zuschneidenden | Fläche ein | ||
kleines | Loch erzeugen. Ein | ||
langes | Stück | gebogenen |
Drahts in das Loch ein- schieben, um zu prüfen, dass hinter der gewählten Stelle keine Hindernisse vorhanden sind.
2.Das Montageloch schnei- den.
3.Das Kabel vom Verstärker zum eben erzeugten Ausschnitt verlegen. An der Ausschnittstelle etwa 30 cm extra Kabellänge vorsehen.
– 7 –