Pass Thru Output
In some very high performance systems, particularly AV systems, multiple subwoofers may be used. When the VPS 210 is used in such a system the Pass Thru output can be used to supply a signal to a second subwoofer. The signal from this output is not affected by the VPS 210 internal crossover. It is the same as the signal that goes into the inputs.
Control Setting and Operation
The VPS 210 controls are located on the top of the cabinet. |
|
|
|
|
The Volume Control is on the left. The other controls are |
|
|
|
|
under a removable cover. To adjust these controls, lift the | 40 | 60 | 0º 180º | OFF AUTO ON |
tab on the right side of the cover to remove it. |
|
|
|
|
| 30 | 150 |
|
|
Power Off/Auto/On Control and Status Indicator | CROSSOVER (Hz) | POLARITY | POWER MODE | |
|
|
|
| |
OFF – Turn the VPS 210 off if you will not be using it. When |
|
|
|
|
the switch is set to “Off” the VPS 210 is Energy Star® quali- | Volume Control |
|
| Status Indicator |
fied.
AUTO – The VPS 210 will turn itself on whenever an input signal is detected. If no signal is detected, after several minutes it will automatically switch to Standby mode. When the VPS 210 is in Standby mode it uses very little power.
ON – The VPS 210 is always on.
The Status indicator shows the VPS 210 power mode:
OFF – The subwoofer is off
AMBER – STANDBY (No signal detected, Amp Off )
BLUE – ON (Signal detected, Amp On)
Volume Control
Start with the Volume Control at the 11 o’clock position. If the VPS 210 does not produce sound check the Status Indicator – it should be lit blue. If it is not lit check the
Adjusting the Crossover Control
When using the Line Level inputs (not the LFE input) the VPS 210
Once you have set the Crossover Control you may want make additional adjustments to Volume Control setting until the transition from main speakers and the VPS 210 is smooth and the sound is balanced. Bass output should not overpower the main speakers but rather be adjusted so there is a natural blend across the entire musical range.
Polarity Control
Selects regular (0°) or inverted (180°) phase for the VPS 210. Set this switch so the system produces the fullest, most dynamic bass. The effect of phase will be most audible on
6
9/24/08 4:19:32 PM