Alarms (continued)
11
Checking the wakeup time
Press the Setup button for Alarm 1 (or Alarm 2). The wakeup time and other alarm settings will flash in the display for a few seconds. To cancel the flashing immediately, press the Setup button again.
Stopping the alarm when it is sounding
Press the On/off button or any other button except the Snooze/Sleep button. The alarm will stop, and will trigger again at the same time the next day.
Disabling the alarm (for weekends, etc.)
Press the Alarm 1 (or Alarm 2) button repeatedly until the alarm icon disappears in the display. The alarm settings will remain stored, but the alarm will not be active.
Using the Snooze function
When the alarm sounds, press the Snooze/Sleep button on the MicroSystem CD or the Sleep button on the Remote Control once to silence the alarm for 10 minutes.
If the Snooze/Sleep button or the Sleep button is pressed again within 3 seconds of the first push, 5 minutes will be added to snooze time, up to a maximum of 60 minutes. Example: If the button is pushed rapidly three times, the MicroSystem CD will go into snooze mode for 20 minutes (10 + 5 + 5 minutes).
Once the MicroSystem CD is in snooze mode, tapping the Snooze/Sleep or Sleep button will display the remain- ing snooze time, counting down. The display will then revert to normal after 5 seconds.
