DTS Pro Series Surround Encoder – Installation and User Manual
12.Repeat step 11 for the other channels.
Sample rate
Bit depth
Duration (hh:mm:ss:ff)
Input files have been selected for all channels. For each input file, the sample rate, bit depth, and duration is identified. See note 1, below.
Use the duration information to check that the input files are identical in length. See note 2, below.
Special Case: This packer will accept a stereo source file to assign to a single channel.
The pulldown on the right is to select channel 1 or channel 2 from a stereo source file.
Note 1: If the sample rate of the input file does NOT match the sample rate you have chosen for the output file, a red outline will appear around the input file s sample rate, as shown in this example.
Input file sample rate does not match the selected output sample rate. In this case, you must change the output sample rate to match (step 4) or provide inputs of the proper sample rate.
Note 2: If the duration (length) of an input file does NOT match the duration of another input file, a red outline will appear around the input file s duration, as shown in this example.
The duration of all input audio files must be the same.
13.Next, there are three choices. Choose Pack and Encode (to both pack and encode at this time) or choose Pack local file (if you are going to pack the file now but it will be encoded later — see page 12). Choose Close, if you do not want to continue. (Your selections so far will be discarded.)
10
