Manuals
/
Brands
/
Household Appliance
/
Water Heater
/
Bradford-White Corp
/
Household Appliance
/
Water Heater
Bradford-White Corp
- page 40
Models:
C)*(N
CX)
PDX Series Powered Direct Vent Gas Water Heaters
PDX250T6*F(BN
PDX265T6*F(BN
PDX275T6*F(BN
PDX50S60F(B
PDX65S65F(B
PDX75S70F(B
X)
1
40
40
Download
40 pages, 1.67 Mb
Email
parts@bradfordwhite.com
techserv@bradfordwhite.com
www.bradfordwhite.com
Contents
Main
Bradford White
PDX Series
Powered Direct Vent Gas Water Heaters
Table of Contents
WARNING:
FOR YOUR SAFETY
Introduction
Tools Required for Service
Specifications
Vent Tables
Control Timings
Specifications
Power up Sequence
Normal Heating Sequence
Steady state operation.
Thermostat satisfies. Burner off. Blower post purge (15 seconds).
Sequence of Operation
Abnormal Operation
1. Simulated Resistive Device Fault:
Normal Heating Sequence (cont.)
2. Temperature Sensor Fault:
Sequence of Operation
Abnormal Operation (cont.)
3. Pressure Switch/Blower Temperature Fault:
4. Trial For Ignition Fault:
5. Flame Sensing Fault:
Troubleshooting
LED Status
Control Status
Service Procedure
Probable Cause
LED Status Control Status
Service Procedure
Probable Cause
Troubleshooting
Burner Inspection and Air Shutter Adjustment.
Cast Iron Burner Air Shutter Adjustment
Burner Cleaning
Pilot Inspection, Testing and Replacement
PDX SERVICE PROCEDURE III Pressure Switch Testing and Replacement
Exhaust Pressure Switch Testing
Exhaust Pressure Switch Replacement
PDX SERVICE PROCEDURE III Pressure Switch Testing and Replacement
Inlet Pressure Switch Testing
Inlet Pressure Switch Replacement
PDX SERVICE PROCEDURE IV Blower Testing and Replacement
115 volt potential exposure. Use caution when
Blower Testing
Blower removal
Blower Installation
Blower Temperature Switch Testing.
Blower Temperature Switch Replacement.
Thermal Well Testing
Gas Control Testing
Determine Water Temperature Inside Tank
Gas Control & Thermal Well Removal From Water Heater
Gas Control Removal From Thermal Well
Gas Control Assembly to Thermal Well
Flammable Vapor Device Testing
PDX SERVICE PROCEDURE VIII Safety Circuit Voltage Trace
Safety Circuit Voltage Trace
NOTE: This procedureassumes a cool tank.
PDX SERVICE PROCEDURE IX 120 VAC Trace
120 VAC Circuit Trace
Dip Tube Inspection and Replacement
Anode Inspection and Replacement
Remove blower to gain access to flue baffle
Inner Door Removal Procedure.
Inner Door Gasket Replacement Procedure.
Installation of Inner Door With Gasket.
Installation of inner door with gasket (continued from page 36).
Page
Parts List