Express® Lavatory System - MG-Series with TouchTime® Control | |
MG-2/TT | Installation Instructions |
Pre-Installation Information
Barrier-free and ADA compliant - standard height mounting
The MG-2/TT Express® Lavatory System must have a rim height no higher than 34" above finished floor to be compliant with Americans with Disabilities Act (ADA). When mounted at 34" rim height, the MG-2/TT Express® Lavatory System meets ADA, ANSI and UFAS requirements for barrier-free clearances, reaches and controls. Always check local codes and ordinances for compliance.
Barrier-free and ADA compliant - juvenile height mounting
The MG-2/TT Express® Lavatory System must have a rim height no higher than 30" above finished floor to be compliant with Americans with Disabilities Act (ADA) Accessibility Guidelines for Buildings and Facilities: Building Elements Designed for Children's Use; Final Rule.
Texas Accessibility Standards compliant:
The MG-2/TT Express® Lavatory System meets Texas Accessibility standards (TAS) for barrier-free clearances, reaches and controls. Always check local codes and ordinances for compliance.
TouchTime® switch and solenoid
Each sprayhead is controlled by a TouchTime® switch, enabling each user to activate a single flow of water. Each valve uses less than half the maximum of hot water allowed by the ANSI/ASHRAE/IESNA 90.1-1989 Standard.
Supplies required for installation:
•(8) 3/8" wall anchors, bolts and washers to mount frame and bowl to wall (minimum pull-out rating of 1,000 lbs.)
•1/2" NPT hot and cold supply piping and 1-1/2" NPT drain piping
•1/2" NPT street elbow
•110 volt electrical outlet for 110/24 VAC plug-in transformer (supplied)
•240/208-volt or 277-volt electrical outlet for optional electric tankless water heater
2 | 2/8/07 | Bradley Corporation • 215-1480 Rev. E; EN 06-915 |
