Bradley Smoker SS-2/AST/STD, SS-2/AST/JUV installation instructions Connecting plastic tubing

Express® Lavatory System SS-Series
SS-2/AST/STD, SS-2/AST/JUV	Installation Instructions - For Service Only

Installation Instructions continued . . .

Step 5: Connecting plastic tubing

NOTE: Refer to Figure 8a for hot and cold supplies, and refer to Figure 8b for tempered supply.

1.Connect the plastic tubing for the water supplies from the sprayhead assembly to the quick- connect fittings on the air valve as follows:

•insert the tubing with the red marking to the left valve

•insert the tubing with the green marking to the right valve

IMPORTANT: The plastic tubing for the water supplies and pushbuttons are pre-cut to the correct lengths. If the tubing is cut too short, kinking can occur and cause leaks at the fitting locations.

2.Connect the plastic tubing for the pushbuttons from the sprayhead assembly to the quick-connect fittings on the air valve as follows:

•insert the tubing with the red marking to the left valve

•insert the tubing with the green marking to the right valve

3.Assemble the P-trap (supplied) and make drain connections.

	AIR TUBING
	(GREEN)
AIR TUBING
(RED)
WATER SUPPLY	WATER
	SUPPLY
(RED)	(GREEN)
	FLEXIBLE
AIR VALVE	SUPPLY HOSE

	VERNATHERM™
	MIXING VALVE
Figure 8a

				AIR TUBING
				(GREEN)
				WATER
				SUPPLY
				(GREEN)
AIR TUBING
	(RED)
				FLEXIBLE
				SUPPLY HOSE
	WATER SUPPLY
		(RED)
			AIR VALVE

Figure 8b

10 5/11/04 Bradley Corporation • 215-1244 Rev. C; EN 03-813