Bradley Smoker SS-2/AST/JUV, SS-2/AST/STD Rough, Installation Instructions continue

	Express® Lavatory System SS-Series
Installation Instructions - For Service Only	SS-2/AST/STD, SS-2/AST/JUV

Installation Instructions

Step 1: Rough in

Note: See Figure 1a below (for Standard Height) and Figure 1b on page 6 (for Juvenile Height) when roughing in the Express®.

IMPORTANT: Flush the supply lines before making connections. Debris in supply lines can cause the valves to malfunction.

IMPORTANT: Dimensions shown in Figure 1a are for Standard Height and in Figure 1a for Juvenile Height.

1.Rough in 1/2" NPT hot and cold supply lines through wall at dimensions shown.

2.Rough in 1-1/2" NPT drain waste connection through wall at dimensions shown.

3.Install (6) 3/8" wall anchors with a minimum pull-out rating of 1,000 lbs. (supplied by installer) at the locations shown in Figures 1a and 1b.

SS-2/AST/STD Express® Lavatory System Dimensions

Standard Height Mounting

23-1/2"

23-1/2"

(597)

(597)

9-3/8"

9-3/8"

(MM)

(238)

(238)

1"

(25)

2-3/4"

3"

(70)

(76)

1-1/2" NPT DRAIN -

STUB OUT 2" (50)

1/2" NPT HOT AND

FROM WALL

32"

COLD SUPPLIES,

(813)

OR TEMPERED

SUPPLY - STUB

OUT 2" (50) FROM

28-5/8"

(727)

WALL

25"

(635)

(6) 3/8" WALL

15-1/4"

ANCHORS WITH

(387)

11-3/8"

FINISHED

(289)

MINIMUM PULLOUT

FLOOR

RATING OF 1,000

LBS.

Figure 1a

CENTERLINE

Installation Instructions continue . . .

Bradley Corporation • 215-1244 Rev. C; EN 03-813 5/11/04 5