Power-up Configuration and Self-Test | Brady 1024 specs

1.10Power-up Configuration and Self-Test

With the Printer off, load the media to be used (at least 4 inches wide) and ribbon (if equipped and/or desired). Press and hold the Feed Button and turn the Printer on, continue holding the Feed Button until the media begins to move then release the Feed Button. The Printer will automatically detect if a ribbon has been installed, and the Printer will then print the two test labels.

Note: After performing a Power-Up and Self-Test, the Printer will be in 'Character Dump Mode'. Turn the Printer off

momentarily, then back on to restore normal operation.

To reset the Printer to 'Factory Defaults':

With the Printer off, press and hold the Feed Button while turning the Printer ON. Continue to hold the Feed Button for 60 seconds and then release. The Printer will now be set to the 'Factory Defaults'.

The first label printed will be the Configuration Label, which lists the Printer's configuration and status.

FRI SEPTEMBER 026,			1995 19:29 244
ROM CHECKSUMS
U09
U10
SYSTEM	RAM CHECKS____ GOOD			SYSTEM RAM SIZE__ 512
KBYTES
CONFIGURATION
9600,8,N
DIRECT
INPUT VALUES
PAPER:	228	EDGE: 179 REFL: 0 TEMP: 89
POT :	212	TOFA: 133 RIBN:		0
COUNTER INFORMATION
ABSOLUTE VALUES			9-18-1994	RESETABLE VALUES 9-18-
1994
LENGTH____		773 INCHES		LENGTH____	576
INCHES
TIME______			10 HOURS	TIME______	4
HOURS
MEMORY	CONFIGURATION

12	Getting Started

Image 18

Brady 1024 manual Power-up Configuration and Self-Test, To reset the Printer to Factory Defaults

Contents

Logo W.H. Brady Co Automatic Indentification Products Part Number Revision C Agency Compliance and Approvals Important Safety Instuctions Contents Appendix C Appendix aAppendix B Appendix D Introduction Unpacking and Inspection Mechanical Printer SpecificationsPrinter Specifications Media/Ribbon Fonts CommunicationsElectrical Available Bar Codes Options Connecting Power External Power Supply Switches and Indicators Switches and Indicator Locations Interfacing to the Printer Interfacing Loading Media Media Loading Loading Media for Peel Configuration Peel Off Media Loading Loading Ribbon Ribbon Hub Removal Selecting Print Type Adjusting for Wide or Narrow Ribbons Adjustments for media Direction of Rotation Effect Power-up Configuration and Self-Test To reset the Printer to Factory Defaults 11 Configuration Test Label Available Options 12 Printhead Test Label Memory Cartridges Modules Printing Labels Programming Commands Immediate Commands Char Description Format System Level Commands System Level Commands Label-Formatting Commands Description Format Label Formatting Commands Special Label Formatting Commands Font Loading Commands Programming Examples Configuration Command String STXKDwxy CR where wExample @ Sets the Printer to gap edge media no linerless Printing Bar Codes Example line Memory Cartridges Modules Inserting Memory Cartridge Cleaning the Printhead Cleaning Printhead Media Width Adjustment Adjusting Media Width Fine Printhead Adjustment Fine Printhead Adjustment Printhead Replacement Printhead ReplacementPage Ascii Control Code Chart For the software handshake XON/XOFF commands Char Dec Hex Available Fonts and Bar Codes FontsTable B-1 Valid Human Readable Font Ascii Characters Table B-2 Font Sizes Appendix B Appendix B Table B-3 Bar Code Characteristics Bar Codes Hbic Bar Code I Codabar Bar Code T Telepen Uppercase R Error CodesLowercase Uppercase T Appendix C Appendix D Warranty Information Thermal Printhead Warranty Service Procedures General Warranty Provisions Limitation of Liability Page Insert Free Roll of Labels Reply card for Printer