![](/images/new-backgrounds/1196972/19697251x1.webp)
trimmer |
aning |
trimmerer |
on |
Series | Series |
| |
release |
|
er |
oil |
Series 7 |
release |
click! |
Series 7 |
release |
trimmer |
Shaving with the cord
If the shaver has run out of power (discharged), and you do not have the time to recharge it in the Clean&Renew station, you may also shave with the shaver connected to an electrical outlet via the special cord set.
Cleaning
Automatic cleaning
After each shave, return the shaver to the Clean&Renew station and proceed as described above in the section «Before shaving».
All charging and cleaning needs are then automatically taken care of. With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles.
The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks.
The cleaning cartridge also contains lubricants, which may leave residual marks on the outer foil frame after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper.
Manual cleaning
The shaver head is suitable for cleaning under running tap water.
Warning: Detach the shaver from the power supply before cleaning the shaver head in water.
Rinsing the shaving head under running water is an alternative way to keep the shaver clean, especially when travelling:
•Switch the shaver on (cordless) w and rinse the shaving head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
•Next, switch off the shaver, press the release button 9 to remove the foil and cutter cassette 8 and let it dry.
•If you regularly clean the shaver under water, apply a drop of the light machine oil, included with the shaver, onto the shaver foil and long hair trimmer. This is critical for proper functioning of the shaver as washing under water can lead to removal of lubricants from the shaver’s cutting parts leading to higher friction in the shaver. This may result in the
26