Kenmore 362.61020, 362.72232, 362.72221 manual Special Care of the Continuous Cleaning Oven Interior

Special Care of the Continuous Cleaning Oven Interior

(on some models)

The special coating is a porous ceramic material, which is dark in color and feels slightly rough to the touch.

The continuous cleaning oven cleans itself while cooking. The oven walls are finished with a special coating that cannot be cleaned in the usual manner with soap, detergents, steel wool pads, commercial oven cleaners, coarse abrasive pads or coarse brushes. Use of such cleansers and/or the use of oven sprays will cause permanent damage.

If magnified, the surface would appear as peaks, valleys and sub-surface "tunnels1" This rough finish tends to prevent grease spatters from forming little beads or droplets that run down the side walls of a hard-surface oven liner, leaving unsightly streaks that require hand cleaning.. Instead, when spatter hits the porous finish,

it is dispersed and partially absorbed This spreading action increases the exposure of oven soil to heated air and makes it somewhat less noticeable..

Soil may not disappear completely and at some time after extended usage, stains may appear that cannot be removed.

'The special coating works best on small amounts of spatter, it does not work well with larger spills, especially sugars, egg or dairy mixtures.. The oven bottom does not have the continuous cleaning oven coating and can be removed and cleaned with a commercial oven cleaner.

This special coating is not used on the oven shelves, oven bottom or the inside of the oven door. Remove

these to clean with a commercial oven cleaner to prevent

damaging the continuous cleaning oven coating.

Make sure the oven bottom is in place before you turn the oven on for any reason.

Use care in removing and replacing the oven bottom and shelves and in placing and removing dishes and food to avoid scratching, rubbing or otherwise damaging the porous finish on the oven walls.

To Clean the Continuous Cleaning Oven:

1o Let range parts cool before handling. We recommend rubber gloves be worn when cleaning..

2, Remove shelves and cookware.

3.Soil visibility may be reduced by operating the oven at 400°F (204°C). Close the door and turn OVEN TEMP knob to 400°F (204°C).. Time for at least four hours. Repeated cycles may be necessary before improvement in appearance is apparent..

Remember; During the operation of the oven, the door and other range surfaces will get hot enough to cause burns, Do not touch, Let the range cool before replacing the oven shelves,

4.If a spiltover or heavy soiling occurs on the porous surface, as soon as the oven has cooled, remove as much of the soil as possible using a small amount of water and a stiff-bristle nylon brush Use water sparingly and change it frequently, keeping it as clean as possible, and be sure to blot it up with paper towels, cloths or sponges. Do not rub or scrub with paper towels, cloths or sponges, since they will leave unsightly lint on the oven finish. If water leaves a white ring on the finish as it dries, apply water again and blot it with a clean sponge, starting at the edge of the ring and working toward the center..

The oven bottom has a porcelain enamel finish.

The oven bottom comes out for cleaning away from the continuous cleaning oven.,

The inside of the oven door has a porcelain enamel finish. The oven door lifts off for cleaning away from the continuous cleaning oven.. For instructions on how to clean the inside of the oven door refer to the Lift_Off Oven Door section.

Do not use soap, detergent, steel wool pads, commercial oven cleaners, silicone oven sprays, coarse pads or coarse brushes on the porous surface. These products will spot, clog and damage the porous surface and reduce its ability to work°

Do not scrape the porous surface with a knife or spatula--they could permanently damage the finish.

27