Braun A2 service manual  0UMP-ODULE 0ARTSR,IST

.6,)" 0UMP)-ODULE 0ARTSR,IST

Item

Qty.

Description

Part No.

	1	Pump Module (complete), 12 Volt, Rear		985-A2516RNA
1	1	Pump Assembly (M268-0112) 12V-120G - Duel Relief (Includes Items 2 & 3)		30915-12V
2	1	Power Cable, Up Solenoid to Motor		29049
3	1	Solenoid, Up - 4-Post - Trombetta (Flat Mount)		31374
4	1	Diode Assembly, Up Solenoid		73906A
5	2	Nut, #10-32 Serrated Flange		83080
6	1	Fitting, Male 7/16-20 O-Ring to Male 7/16-20 JIC 37°		24504
7	1	Elbow, Female Swivel 7/16-20 JIC 37° to (2) Male 7/16-20 JIC 37°		26579
8	1	Control, Hand Pendant Assembly - Standard (Includes Items 9-17)		100063-001
9	1	Keypad, Hand Control		30000
10	1	Hand Pendant Case - Front		100027-001
11	1	Seal, Hand Control - Standard		100066-001
12	1	Module, Hand Control		100041-001
13	1	Screw, 10-32 x 1/2”, Phillip, Pan Head		82744
14	1	Hand Pendant Case - Rear		100028-001
15	1	Hanger, Round - Hand Control		73793
16	2	Screw, #4-40 x 1/4”, Phillip, Pan Head		11480
17	1	Cord, Coiled - 6-Conductor		100044-001
18	1	Strain Relief - Liquid Tight		30753
19	1	Control Board Assembly		100159-001
20	8	Standoff, Snap-In (2 shown)		31011
21	1	Switch, Push Button		31753
22	1	Diode, Green LED, Panel Mount		29545
23	1	Stud, Power Feed		26084
24	1	Rubber Boot, Red tSee note below		82046
25	1	Cover, Pump, 2-Piece - Back (Complete Assembly 915-0513RNA Includes Items 25 - 32)		915-0513RN
26	1	Recepticle, Clip On		28803
27	1	Lens, Threshold Warning - Red		30704
28	1	Decal, Warning / Pressure Relief Valve (Not shown - see Decal Section)		22249
29	1	Spacer, Lens - NHTSA		31386
30	1	Metal Ring Base - Lamp		30971
31	1	Socket, Lamp		30703
32	3	Screw, #8-32 x 1/2” Pan Head Phillips - Thread Cut		30974
33	1	Bulb, Light		19841
34	1	Switch, Toggle		12185
35	1	Decal, Lift Power - On/Off (Not shown - see Decal Section)		21494
36	2	Washer, 5/16” Flat		10063
37	2	Bolt, 5/16-18 x 3/4”, Nylock, Hex	* See note below	29608
38	2	Bolt, 5/16-18 x 1/2”, Nylock, Hex	* See note below	10012
39	1	Cable, Ground		22166A
40	1	Washer, 5/16” External Tooth		16368
41	1	Beeper, Continuous		30487
42	1	Wire Assembly, Lift Interlock Connection		31797A
43	1	Wire Assembly, Lift Stowed Connection		31798A
44	1	Plate, Backing / Mounting - Rear		985-2501RN
45	1	Pump Handle with Grip		17206A
46	1	Clamp, Hose - Solenoid Mounting		29663
47	1	Solenoid, Up - 4-Post - Prestolite		28308
48	1	Cover, Pump - 2-Piece - Top / Front (Complete Assembly 985-0519RNA Includes Items 48 - 59)		915-0519RN
49	1	Stud, Wing Head - 1/4 Turn		28804
50	1	Retainer, Push On		28805
51	1	Plug, Window - Clear		30443
52	1	Clip, Pump Handle - Top		915-5517
53	1	Washer, Nylon, 1/4” I.D. x 11/16” O.D. x .030”		12690
54	1	Clip, Pump Handle - Bottom		915-5518
55	3	Rivet, Pop, SD43BS - 1/8” - .13”/.19”		12954
56	1	Decal, Removal / Installation Pump Handle (Not shown - see Decal Section)		29052
57	1	Decal, Manual Instructions - Public (Not shown - see Decal Section)		31412
58	1	Decal, Removal / Installaton - Pump Cover (Not shown - see Decal Section)		29051
59	1	Decal, Warning - Control Board Damage - ESD (Not shown - see Decal Section)		30787
60	1	Cable, Pump Module Power Hookup (Not shown - see Wiring Diagram)		26082A-4
61	1	Harness, Power (Not shown - see Wiring Diagram)		985-A2530NA
62	1	Harness, Interlock / Lighting (Not shown - see Wiring Diagram)		985-0531NA
63	1	Harness, Up / Down Solenoid (Not shown - see Wiring Diagram)		985-2533NA
64	1	Harness, Extension - Threshold Switch (Not shown - see Wiring Diagram)		985-A1534NA
65	1	Harness, Jumper (Not shown - see Wiring Diagram)		985-2541NA

*Apply red #271 Thread Locker Loctite® to the four hex bolts (items 37 and 38) if a blue nylon patch is not present on the bolts when retrofitting an M268-0112 pump assembly. Loctite® is available from The Braun Corporation under part

number 11522.

tIndicates items available for replacement part purposes only. These items are not included with replacement pump modules.

Page 11